My gas tank is building too much pressure. When I take the cap off it blows out a lot of pressure. Even after a few minutes in the hot sun. I checked the anti roll over valve and I can blow through it with the key on. Then I installed the vent hose back on the tank so I can blow through it. I couldn't so I used my blow gun with over 100lbs of pressure. It still wouldn't blow through. Then I bunched a shop rag as a seal and put my blow guy in it to blow pressure. Still no air coming out the vent. I even tried to run a small wire in the vent hole to see if it was restricted. It wouldn't go through. It might be baffled though. This all happened after I took the tank off to check out my fuel gauge sender that wasn't working. I turned the tank upside down when I did this. Besides doing the gas cap venting mod, what do you guys suggest?
Ultra Star Forum
Wind Therapy Riders
Star Chapter 434
The administrator has disabled public write access.
The Road Star Clinic
is a collaborative community of riders who archive and publish user contributed technical
data about Yamaha Road Star motorcycles.
We also sponsor the creation and support of other community websites similar to our own. Inquiries
about availability of a website for your community can be submitted to us via any "Contact Us" option
on the Clinic.
Copyright 2003-2007 Road Star Clinic and its respective authors. Road Star Clinic is sponsored by the folks at MLSHomeQuest.com.