As some of ya know I sell 3" floorboard extenders and I have a new batch ready to go.They are lasercut and powder coated gloss black. I include all hadreware and istructions for installation. The hardware I supply is Stainless steel and the nuts are nylock so you dont have to worry about them comeing loose and or rusting. They are fully adjustable up to 15 degrees for tilting and will work with your factory brake lines and your shift linkage. I didnt want to start another thread, but the other was a little long. I did make a small change to them so I could keep them reasonably priced for you guys, I had to leave out the countersink in the two mounting holes that inset the buttonheads, it doesnt affect the mounting and makes it better for the guys with 1600s. They will fit 1600- 1700 1998-2008


So that I can keep bumping this up PLEASE PM me with any ?????????
They are also listed in the classifieds with my ###

Thanks Bill

Hey All! I Highly Recommend these! Bill does a great job on them, and I believe they are much better than inferior knock offs on Ebay! Great price, Great Guy! If you want some more room and some adjustable Tilt for your Boards, Give this man a PM or Call!!!! Highly Recommended!!!

Bill check you PM.

Yakman

Bill,how much and do you use paypal.Thanks,Richard.

cam21 wrote:
Bill,how much and do you use paypal.Thanks,Richard.

You have a PM.

I could use a set of them. How does it affect the shift rod assembly?

1700cc wrote:
I could use a set of them. How does it affect the shift rod assembly?

You just readjust it, it tells ya in the instructionsI send with them.

I sent ya a PM, did ya get it????????

Got it, thanks big guy!

Bill,
will they work with the Yamaha big bar?
Darrin

It's too bad that nobody makes a brake line that's 3 to 4 inches longer so we all could properly utilize great products like Bills