I was in the garage mocking up my hard bags. I wanted to be sure that the bag was lined up properly from the back so I placed a couple of 2 x 4's under the kickstand to get it as vertical as possible without it falling over.
I got the bike up, aligned the bag as I want and then took the bag off and placed it beside me. I then went to the back to look at the alignment of the bag support .... and watched my bike slowly fall to the ground.
I'm stood there shocked watching gas leak out the top of my gas cap, then walked over and picked it up.
Usually there would be no damage as the FC's do a good job of stopping the tank from hitting the ground
but ... the hard bag was beside the tank and the tank hit the bag causing a couple of small creases.
Luckily I bought another tank (now was 2 spares

), so I do have replacements but I also wanted to redo the graphics on this tank. I think the design I have in mind is within the perimeter of where the damage is so I won't have to re-spray the whole tank ... but still .... I have enough to do without this extra unforseen work.
Doc
.
