zip ties, short piece of wire, fuel filter, 6-7 feet fuel line, hose clamps, brackets from hardware store
been a while so forgive any ommission but it's really simple use you head.
shut off the gas valve before you start
and let run for a while and pull tank
easier if you pull the tank - tip put a towel over the bars and hang the guage over the top. and put the key in your pocket, if you dont disconnect the battery
pull the pump assembly and lines
you'll see the pumps rubber mount slides onto a metal tab
the relay mount under the cover has an extra tab
cut the filter part of the rubber mount off
dry fit it for clearance
extend the power wire - solder and/or at least heat shrink it
run fuel line - watch out for kinks, pinches, rubbing, and heat!! and the same for the fuel line
remember you'll be bent over and the woman might be around, well..................
remount the choke as you like...for mine see other post in this thread
bonus tip - in the fuel inlet on the
carb and I mean 'in' it there is a small back up filter, pull it out and toss it....
in all i think less than $30 with the nice filter
Favoured: 0
dern sorry i know that aint good
but ....
) but we felt that there are numerous websites that can be easily found where on can go. There is no 18+ or restricted access Forum here.
