Assembling the Engine’s Left Side
Written by Randy Fox
Saturday, 03 November 2007
Page 2 of 3
Installing the Primary Drive Assembly
Take picts of the engine’s left side.
Bolt on the primary drive gear assembly, including its key, pickup coil rotor, and spacer washer, but do not torque the bolt yet.
Installing the Oil Pump Driven Gear Assembly
Install the oil pump driven gear assembly, including the brass oil-delivery tube. Remember to include the three, little O-rings for the oil-delivery tube. See photo above.
Installing the Shift Shaft Assembly
Next, install the shift shaft assembly.
Tip: I forgot to install the shift shaft assembly until after my clutch was completely in (Not one of my better moments). But I was able to get the shift shaft assembly installed without having to take the clutch back out. To do this, I used a little wire-tie on the shift shaft, to pull the lever clear. Then I just snipped off the wire-tie once the shift-shaft was in. See photo below.
Copyright 2003-2007 Road Star Clinic and its respective authors.
The Road Star Clinic
is a collaborative community of riders who archive and publish user contributed technical
data about Yamaha Road Star motorcycles.
We also sponsor the creation and support of other community websites similar to our own. Inquiries
about availability of a website for your community can be submitted to us via any "Contact Us" option
on the Clinic.
Road Star Clinic is sponsored by the folks at MLSHomeQuest.com