Installing Barons lower chrome guard
Written by Steve Shiver
Thursday, 10 June 2004
Without having to loosen or remove the rear wheel !
Reprinted by Permission from Mr Tidy's Tech Tips
Remove saddlebag if necessary and remove front saddlebag bolts and footpeg. Place a cotton sock over the end of the saddlebag bracket to protect paint (or remove side cover). Remove the front bolt at the seat/fender/saddlebag bracket support and rotate the bracket up 3-4 inches.
Remove the upper chrome belt guard. You can then remove the plastic lower guard.
Put an old cotton T-shirt over the lower swing arm to protect both the paint and chrome.
Slide the new chrome lower guard in per Barons directions. (Slide rear of guard in angled down and then lower front edge in. Then rotate top of guard in under upper swing arm).
Reverse removal process for upper guard and saddlebags. I replaced the supplied chrome bolts with stainless steel bolts.
Questions should be asked in our forum (Use discuss link below).
The forum is very active and you stand a good chance of getting your questions
answered there. If you would like to leave feedback
for the author, or have additional information you think will benefit others, please use
the comment section at the bottom of this page.
Discuss this article on the forums. (0 posts)
This information and procedure is provided
as a courtesy and is for informational purposes only.
Neither the publishers nor the authors
accept any responsibility for the accuracy, applicability, or
suitability of this procedure. You assume all risks associated
with the use of this information. NEITHER THE PUBLISHERs NOR THE AUTHORs
SHALL IN ANY EVENT BE LIABLE FOR ANY DIRECT, INDIRECT, PUNITIVE, SPECIAL,
INCIDENTAL, OR CONSEQUENTIAL DAMAGES, OF ANY NATURE ARISING OUT OF OR IN ANY WAY
CONNECTED WITH THE USE OR MISUSE OF THIS INFORMATION OR LACK OF INFORMATION.
Any type of modification or service work on your motorcycle should
be performed by a
If performed incorrectly,
this procedure may
endanger the safety of you and others
on your motorcycle and possibly
invalidate your manufacturer’s warranty.
Quote this article on your site | Views: 22161
|Replacing Final Drive Belt on 05' Road |
Written by tusekiaharjo, on 09-06-2011 14:29
Does anybody out there have information on how to replace the final drive belt on a 2005 Road Star Silverado? I need to change mine but would like to do it myself. Thanks
|Written by 1700cc, on 10-11-2008 16:46 |
I was able to install the bottom guard without removing the top guard. I did remove the hard bag and bracket completly to make it easier. It sure beats messing with the tire!
Only registered users can write comments.
Please login or register.
Powered by AkoComment Tweaked Special Edition v.1.4.6
AkoComment © Copyright 2004 by Arthur Konze - www.mamboportal.com
All right reserved
Copyright 2003-2007 Road Star Clinic and its respective authors.
The Road Star Clinic
is a collaborative community of riders who archive and publish user contributed technical
data about Yamaha Road Star motorcycles.
We also sponsor the creation and support of other community websites similar to our own. Inquiries
about availability of a website for your community can be submitted to us via any "Contact Us" option
on the Clinic.
Road Star Clinic is sponsored by the folks at MLSHomeQuest.com